WhichPartFits.com

Trimmer

Stihl FS 130 R

4-Mix · Also known as: FS 130

The Stihl FS 130 R is a 36.3cc 4-Mix professional trimmer built for sustained heavy-duty brush cutting — brambles, saplings, and dense perennial growth — sharing the 4-Mix engine architecture with the FS 90 through FS 111 series but specifically calibrated for rigid blade work rather than standard trimmer heads. Gearhead grease repacking every 25 hours under production brush-cutting is recommended. Annual valve clearance inspection and fuel system service round out the maintenance schedule. A preferred model for right-of-way and vegetation management crews.

Verify before ordering: Fitment can vary by serial number, production date, region, and sub-model. Match the OEM number and physical dimensions before ordering.

Stihl FS 130 R quick specs

Equipment
Trimmer · 4-Mix
Covered Parts
Spark Plug, Air Filter, Fuel Filter, Carburetor, Recoil Starter, Ignition Coil, Primer Bulb, Fuel Line Kit, Trimmer Head, Trimmer Line
OEM References
0000 400 7009, 4180 120 1800, 0000 350 3502, 4180 120 0608, 4180 080 2102, 4180 400 1300, 4226 121 2700, 4180 350 1402, 4002 710 2193
Model Family
FS 90 R, FS 100, FS 110, FS 111 R, FS 130 R, FS 131 R
Data Confidence
Not yet independently reviewed

Quick Fitment

As an Amazon Associate, WhichPartFits earns from qualifying purchases.

Tune-Up Kit

Common service bundle: spark plug, air filter, fuel filter, carburetor, primer bulb, fuel line kit.

Maintenance Interval

Inspect filters and fuel lines each season, replace spark plugs during annual service, and service carb/fuel-system parts when starting or idle symptoms appear.

Before You Buy

  • Confirm the full model is Stihl FS 130 R, not just the family name.
  • Check serial number, production date, and regional variant before ordering.
  • Match the old OEM number stamped on the removed part when available.
  • Compare dimensions, plug gap, thread, fuel line diameter, or chain pitch/gauge where applicable.

Common Mistakes

  • Ordering from a family listing without checking the exact sub-model.
  • Buying a kit that includes the headline part but wrong gaskets, lines, or bulb size.
  • Choosing the wrong carburetor revision when multiple versions were used.
  • Assuming all fuel line kits use the same diameter and routing.
  • Installing the correct plug number with the wrong gap.

Symptoms Map

Won't start

Spark plug, fuel filter, primer bulb, carburetor

Starts then dies

Fuel filter, fuel line kit, carburetor

Bogs under throttle

Air filter, carburetor, spark plug gap

Primer will not fill

Primer bulb, fuel line routing, in-tank filter

Replacement Options

Best OEM equivalent

Start with OEM references 0000 400 7009, 4180 120 1800, 0000 350 3502, 4180 120 0608 and match the removed part before choosing a listing.

Named part options

Cross-check named parts such as NGK CMR5H (spark plug), Zama C1Q-S216 (carburetor), Stens 150-570 (recoil starter) against the OEM number, identity label, and dimensions.

Best for annual tune-up

Bundle spark plug, air filter, fuel filter when servicing the Stihl FS 130 R at the start of the season.

Best if replacing fuel system

Compare the fuel filter, carburetor, primer bulb, fuel line kit together so line routing, bulb size, filter style, and carburetor connections match.

Best budget kit

Use kit listings only when every included part matches this model page; cheap kits often mix correct headline parts with wrong bulbs, lines, or gaskets.

FAQ

Should I buy OEM or aftermarket parts for the Stihl FS 130 R? Use OEM when the part controls fuel metering, ignition, or safety. Aftermarket kits can be useful for routine filters, bulbs, plugs, and tune-up bundles when the OEM number and dimensions match.

How do I avoid ordering the wrong carburetor for the FS 130 R? Match the carburetor number stamped on the removed unit, then compare linkage, choke setup, primer routing, gasket stack, and fuel-inlet direction.

What should I check before replacing fuel-system parts? Photograph the old fuel-line routing, match line diameter and filter style, and compare primer bulb size before buying a kit.

As an Amazon Associate, WhichPartFits earns from qualifying purchases. Match the OEM number, dimensions, and model variant before buying.

Spark Plug

OEM0000 400 7009
Dimensions
0.7mm gap
Variant notes
10mm thread (CMR5H) — do not substitute BPMR7A (14mm thread)

Air Filter

OEM4180 120 1800
Variant notes
Also fits FS 87, FS 90, FS 100, FS 110
  • No named part listing is published for this part yet. Use the OEM reference and verify with a dealer or service manual before ordering.

Fuel Filter

OEM0000 350 3502
Variant notes
In-tank pickup filter; also fits BG 85, BR 420
  • No named part listing is published for this part yet. Use the OEM reference and verify with a dealer or service manual before ordering.

Carburetor

OEM4180 120 0608
Variant notes
Zama C1Q-S216; 4-Mix diaphragm carb

Recoil Starter

OEM4180 080 2102
Variant notes
Fits FS 90 R, FS 100, FS 110, FS 130 R

Ignition Coil

OEM4180 400 1300
Variant notes
Fits FS 90 R, FS 100, FS 110, FS 130 R
  • No named part listing is published for this part yet. Use the OEM reference and verify with a dealer or service manual before ordering.

Primer Bulb

OEM4226 121 2700

Fuel Line Kit

OEM4180 350 1402
Variant notes
Includes fuel pickup line and return line; replaces 4180 358 7700

Trimmer Head

OEM4002 710 2193
Variant notes
AutoCut C 26-2; bump-feed

Trimmer Line

OEMSpec-based fitment
Dimensions
.095" diameter, round